All in one harness to fix CANbus and PWM errors for any LED headlight and fog light conversion
For use with Concept or Xtreme LED bulbs to add load to any vehicle lighting system. Add on 15W of load to the headlight system to offset the error caused by the CANBUS system. A wire wound resistor potted inside of a aluminum heat sink with the vehicle specific connector.
For use with Concept or Xtreme LED bulbs to add load to any vehicle lighting system. Add on 15W of load to the headlight system to offset the error caused by the CANBUS system. A wire wound resistor potted inside of a aluminum heat sink with the vehicle specific connector.
- Error cancelling wiring harness for vehicles equipped with CANbus and PWM system
- Eliminates flickering, on and off flash, and dashboard warning lights and other vehicle electrical system complications
| Attributes | |
| Add-On | N/A |
| California Proposition 65 | WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov |
| Country of Origin (Primary) | CN |
| Current Draw@12VDC | 1.2 |
| Hazardous Material Code | N |
| Housing Material | Cast Aluminum |
| IP Rating | IP65, IP67, IP67 |
| Life Cycle Status Code | Available to Order |
| Maximum Amperage | 1.5 |
| NAFTA Preference Criterion Code | B |
| Operating Temperature | -40 to 185 |
| Operating Voltage | 9-16 DC Voltage |
| Resistance | 12 |
| SDR Required Flag | N |
| Universal Or Specific Fit | Specific Fit |
| Voltage | 9-16V, 9~16 |
| Warranty Time | 1 |
| Wattage | 15, 21 |
| GTIN | 00793888980884 |